Protogate Freeway 3600 Guía de instalación descargar pdf (Pagina 19)

Freeway 3412 Hardware Installation Guide Chapter 4. Conﬁguring the Boot Parameters Using an Init Diskette

Boot Parameter Description

FTP User Name If booting from the boot server, Freeway uses this name to log in to its FTP (or RSH)

user account. The default is freeway. This is not required if you are booting from the

local disk.

FTP Password If booting from the boot server, Freeway uses this password to log in to its user account.

The default is password. This parameter is optional. If a password is given, FTP is

used during system boot; if it is cleared, the remote shell (RSH) protocol is used.

Flags This parameter speciﬁes whether you want Freeway to:

• Autoboot two seconds after system reset, seven seconds after system reset, or not

at all

• Force the primary boot network interface to operate at 10 megabits/second, half

duplex

Enter the Flags value shown in

Table 4-2 that matches your conﬁguration

requirements. The default Flags value is 0. The Flags word is an inclusive "OR" of the

desired bits for the individual functions.

Freeway Server Name Enter the system name assigned by the system administrator for this Freeway.

Freeway Inet Address Enter the Internet address assigned by the system administrator for this Freeway in

decimal dot notation (for example, 192.168.1.193).

Freeway Subnet Mask If your Freeway is located on a subnet, enter the subnet mask in hexa- decimal notation

(for example, ffffff00).

Boot Server Name Enter the name assigned by the system administrator for the boot server. Optionally,

you can clear this ﬁeld and the software will assign the default name "bootserver." If

you are booting from the local disk, this parameter is ignored.

Boot Server Inet Address Enter the Internet address assigned by the system administrator for the boot server in

decimal dot notation (for example, 192.168.1.2). If you are booting from the local disk,

this parameter is ignored.

System Boot Directory If the Freeway boot ﬁles will be stored in the home directory of the FTP (or RSH) user

account, clear this ﬁeld. Otherwise, enter the full path name of the boot directory. The

default UNIX directory is /usr/local/freeway/boot. The default VMS directory

is SYS$SYSDEVICE:[FREEWAY.BOOT]. For Windows NT versions earlier than 4.0, the

default directory is c:\freeway\boot. For Windows NT 4.0 or later, use the alias you

have set up to point to the freeway\boot directory. To boot from the local disk, set the

system boot directory to /ide.

System Boot File Name Enter the system boot ﬁle name for this Freeway. The default is fw486.

Conﬁguration File Name This parameter contains the ﬁle that Freeway uses to conﬁgure the physical devices and

services. Enter the ﬁle name for your Freeway. The default is bootcfg.pci. For any

Freeway using ICP_IP virtual ICP devices, the default is bootcfg.ip.

Protogate DC-900-2018A 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 30 31

Sin comentarios

Protogate Freeway 3600 Guía de instalación Pagina 19